Rail3D*

   

 

Back to Back signals


There is sometime a requirement to place signals "Back to Back" on the same node.  Ie two signals - in opposite directions - on the same node.  Rail3D does not allow you to place two signals on the same node.

How to simulate "back to back" signals

  • Place nodes and first signal as normal.
  • Where the back to back signal is needed, add a second node a few metres away from the signal node: 

  • Place (modified) signal on the new node

The "modified" signal is the same type of signal, but offset backwards a few metres

  • Use the node nudge (Control+arrow) to move the new node closer to the other signal, until the signal model (the shifted version) site nicely on the bridge:

 


MRG 01/01/2014 08:45:07